Latest News Archive

Please select Category, Year, and then Month to display items
Previous Archive
03 February 2020 | Story Cobus van Jaarsveld | Photo Charl Devenish
Traffic Circle on the UFS Bloemfontein Campus
The Department of Protection Services shares how to #BSafe at traffic circles.

For the majority of drivers, one of the most confusing driving laws is the correct use of a traffic circle, especially in Bloemfontein with the large number of smaller traffic circles constructed over the past few years; also across the University of the Free State (UFS) Bloemfontein Campus.

“In fact, many motorists do not know that there is a difference between a larger traffic circle and a mini traffic circle, other than their size. Can you really be frustrated if someone cuts you off at a traffic circle if you don't know the rules? Arrive Alive has shed some light on the issue,” said Cobus van Jaarsveld, Assistant Director: Threat Detection, Investigations and Liaison in the UFS Department of Protection Services.

What is the difference between the two circles?

A traffic circle is classified as large when it has a minimum diameter of about 16 metres and a 1,5 to 2 metre flattened kerb, which allows heavy vehicles to drive onto a small section of the circle. A mini traffic circle is normally not more than seven to ten metres in diameter and the entire circle is mountable for heavy vehicles.

Are there different rules for each?

Yes – the rule of thumb is that mini traffic circles, which are usually found in residential areas, have the same rules as a four-way stop – first come first served. For larger traffic circles, which are usually found at busy crossings to assist with the traffic flow, you must give way to the right.

Rules to remember at a large traffic circle

As you arrive at a large traffic circle, traffic coming from your right has right of way, regardless of how many cars there are. Wait until there is a gap in the traffic and then ease slowly into the circle. Watch out for other traffic in the circle and be aware that they may not be using their indicators.

Use your indicators

Signal when you are going to turn – switch your indicator on immediately after passing the exit prior to the one you intend taking. If you are taking the first exit, i.e. you're turning left, then flick on your left indicator and keep in the outside/left-hand lane. Keeping in the outside/left-hand lane also works well if you're continuing straight ahead, as your exit is very close. After you've passed the left-turn exit and yours is next, signal left and you're free. If you're turning right or performing a U-turn, keep in the inside/right-hand lane. Only signal left and change into the left-hand lane once you've passed the other exits and only yours is ahead.

Rules to remember at a mini traffic circle

The first vehicle to cross the line has the right of way, so it really works on the same principle as a four-way stop or yield sign. Proceed in a clockwise direction around the circle, without driving on it.

News Archive

DiMTEC teaches on disasters with international counterparts
2009-06-12

 
Photo: Supplied


 

The Disaster Management Training and Education Centre for Africa (DiMTEC) at the University of the Free State (UFS) recently presented a training course on vulnerability and disaster risk management in collaboration with the United Nations University Institute for Environment and Human Security (UNU-EHS).

The focus was on social, environmental and economical vulnerability, global warming and early warning systems.

Dr Fabrice Renaud, Associate Director: UNU-EHS, Dr-Eng. Jörn Birkmann, Head of the section Vulnerability Assessment: UNU-EHS, and Prof. Dusan Sakulsky, Africa Representative: UNU-EHS from Bonn, Germany presented the course, together with Mr Andries Jordaan, Director: DiMTEC and Eugene Poolman, Chief Forecasting Specialist: Disaster Risk Reduction, South African Weather Service.

This course will be presented again at the Novi Sad University, Serbia in October 2009 and September 2010 as well as in Bonn, Germany in May 2010, where it will be part of the UNU PhD block course.

Conducting the training were, from the left: Mr Jordaan, Prof. Sakulski, Ms Awatif Ayadh, DiMTEC student from Sudan, and Dr -Ing. Vilma Hossini, Training Programme Associate: UNU-EHS.

We use cookies to make interactions with our websites and services easy and meaningful. To better understand how they are used, read more about the UFS cookie policy. By continuing to use this site you are giving us your consent to do this.

Accept