Latest News Archive

Please select Category, Year, and then Month to display items
Previous Archive
01 April 2021 | Story Andre Damons | Photo istock
The Easter weekend runs the risk of being a major catalyst for the third wave and people’s behaviour will be the primary driver of transmission for the third wave.

Similar trends as during the festive season of 2020 – when the behaviour of people was driving COVID-19 transmissions and played a role in the second wave – have emerged due to the Easter holidays, and may contribute to a third wave. 
“This means that we can already anticipate gatherings and a higher rate of travel during the next three weeks. As a result of this as well as non-adherence to the non-pharmaceutical interventions, we can anticipate this event to serve as a catalyst for transmission.” 

“If nothing is done to prevent this, it is anticipated that the Free State will see a steady increase and a potential third wave between 17 April and 26 June,” says Herkulaas Combrink, the interim Director of the UFS Initiatives for Digital Futures and PhD candidate in Computer Science at the University of Pretoria (UP).

The Easter weekend runs the risk of being a major catalyst for the third wave

According to him, the vulnerability and population density dynamics in each province, the behaviour of people, and the social norms between communities must be taken into consideration to contextualise the impact of Easter on disease transmission – especially when looking at SARS-CoV-2.

For the Free State, the Easter weekend runs the risk of being a major catalyst that will lead up to the third wave, says Combrink. “If no interventions are put in place and people do not adhere to non-pharmaceutical interventions to mitigate the spread of the disease, then we will see a steady climb and increase in cases up until that time. This means that the behaviour of people will be the primary driver of transmission for the third wave.”

Reducing the severity of the third wave

According to Combrink, who is involved in risk communication and vaccine analytics with other members of the UFS, we may be able to reduce the severity of the third wave if the variant remains the same and the vaccination roll-out plan is in full effect. It will also help if the correct number of people are vaccinated, the general population adheres to PPE and mitigation strategies, and people practise the appropriate behaviour as indicated in all official COVID-19 communication, including the UFS COVID-19 information page.  

According to Prof Felicity Burt and Dr Sabeehah Vawda, both virology experts in the UFS Division of Virology, the current vaccination programme is aimed at reducing the severity of the disease among health-care workers. Prevention of further waves of infection through vaccination will require sufficient coverage to induce at least 70% herd immunity in the country. Currently, no country has achieved that level of herd immunity through vaccine programmes – this is the long-term goal of vaccination. 

“Irrespective of the government’s vaccination programmes and schedules and a virus that may mutate and perhaps become more virulent, the fundamental ways to protect yourself remain unchanged, namely social distancing, wearing of masks, and regular hand washing. People need to realise that this ‘new normal’ is going to be with us for a while and remains the best defence against all SARS-CoV-2 viruses and even provides protection against other respiratory pathogens.”

Vaccines and mutations

The exact frequency of mutations differs between different types of viruses, but generally, SARS-CoV-2 is known to have a slower ‘mutation rate’ than other RNA viruses because of its built-in ‘proofreading’ enzyme. The true mutation rate of a virus is difficult to measure, as the majority of mutations will be lethal to the virus. Irrespective, very few have actually resulted in clinical impact. 

“This highlights the rather gradual process of mutation, so vaccines should remain effective or at least partially effective in the near future, as they elicit antibodies that target different parts of the virus. Continuous surveillance of SARS-CoV-2 is necessary and ongoing to monitor for changes that may impact vaccines and diagnostic tests,” the experts say.

According to Prof Burt and Dr Vawda, scientists are continuously monitoring the situation to detect if the current vaccines would remain effective and to try to adjust them accordingly. How or when the virus will mutate in a clinically significant way is unknown, so at this point, the current vaccines have been shown to be effective against severe disease and hence have application in reducing significant disease. 

“There remains a lot unknown about the extent of protection and the duration of protection, and it is obviously hoped that the vaccine’s immune response in the human body would be able to provide at least some protection or decrease the possibility of severe disease even against potentially newer variants.”

News Archive

Machinery and equipment to the value of R6 million acquired by UFS Instrumentation Division
2015-07-02

Photo: Supplied

At an information session held on the Bloemfontein Campus, the Instrumentation Division in the Faculty of Natural and Agricultural Sciences at the University of the Free State (UFS) introduced its new Computer Numeral Control (CNC) machines to the value of R6 million.

Initially, the primary aim of the Instrumentation workshop was to design, produce, and maintain special research equipment which is unavailable on the market, mainly for academic departments. The small-scale production focused on producing support material and equipment for research work.

However, with new equipment and machinery the Division now also can deliver a service to corporate companies and external associates.
 
The CNC machines include a 5-axis Vertical Machining Centre from Haas imported from America. This is one of only four in South Africa, with two in Johannesburg and one in Cape Town.  The lathe makes it possible to produce sophisticated parts, which were previously cumbersome and difficult to make. The machines also cover a wide spectrum in the mechanical field such as the the FLOW Water Jet, which cuts a wide variety of material ranging from titanium to wood without utilising heat, thus saving electricity. This makes it possible to cut a wide variety of materials.

With the new machinery now available, the Instrumentation Division is able to perform high quality and quantity production with precision.

“The advantage of the machinery is that it stimulates production, and is much faster and more accurate than the conventional way of doing things,” said Pieter Botes, Head of the Division.

Botes explained that, by having students and professional artisans at the university design and manufacture equipment, costs are reduced when compared with the expensive nature of equipment and tools found in the market. In addition, “the machines broaden the scope of research conducted” said Botes. The technical dynamics of the machinery advances the scientific knowledge needed to operate it, so bridging the gap between theory and practice.

The Central University of Technology, Signs Division Bloemfontein, Product Development Technology Station (PDTS), Maizey’s, and Knottco Truckparts are some of the university’s trade partners.

The workshop collaborates with the Chemistry, Physics, Microbiology, Botany, Agriculture, and Electronics departments, as well as the Institute of Groundwater Studies at the UFS, and others. These departments receive services in the form of pipette stands, containers for test tubes, bottles, laboratory trolleys, stands for cadavers for Anatomy, pump repairs, stainless steel bailers, filaments, and heaters.

The Instrumentation Division is, therefore, a vital support unit for the Faculty of Natural and Agricultural Sciences as well as the university at large.

Companies, institutions, or individuals who need the Division’s expertise may contact Pieter Botes on botespds@ufs.ac.za.

We use cookies to make interactions with our websites and services easy and meaningful. To better understand how they are used, read more about the UFS cookie policy. By continuing to use this site you are giving us your consent to do this.

Accept